300 Blackout RN Coated Rifle Bullet

Quality is outstanding. I have not loaded any yet, however I do not see any issues with these. will be purchasing more in the future.

Good quality and as advertised. Consistent weight and diameter. I have to size the down to .308 to work in my Mini 14; after that, it's my favorite subsonic bullet.

Reloading these for a 5in 1/5 twist 300BO AR. I tried the .309 with lil gun powder 8.6gr at COL of 2.200, I use an expander die to slightly bell the mouth of the case. They ran ran at 1040 fps. They cycled good supressed. What I noticed after 10 rounds was I couldn't see the rifling in my barrel due to severe leading. I have shot these before in other barrels with no leading issues. I reached out to hoosier bullets and they sent me a few of the .310 bullets to try. I loaded them the same and tested them again and they shot great and with no leading at all this time. I will be a repeat customer again. Great bullets and a great company.

Took a lil work to get the load right but once I got it they worked great.

I ordered a case of the 220gr .310 sized bullets and loaded with H110. They worked great in my BCA 300Blk 10.5" upper. These are great plinking rounds and make the 300Blk much more affordable to shoot. I will definitely be buying more when I run low.

Worked great as advertised. A couple minor deficiencies, but overall great product for the money. I will be purchasing more. 9.3 grains of H110 in converted brass. 2.250 OAL. They cycle great!

Awesome. They are good quality and sized perfectly at .309. All of equal weight. The coating doesn't rub off, chip or smoke. What I recover from subsonic loads in the bullet trap are still coated where not totally smashed to bare lead. I size the bullets to .308 for reliable feeding in a mini-14. My preferred velocity for this bullet is 1050 fps; they work great.

These will be my go to for subsonic plinking loads from here on out. I started with weighing 20 out to see how close they were. I was surprised, because usually cast bullets have a huge variation in weights, at least from my experience. These all weighed within .2 grains of each other. The only thing is, most were 217.2-217.4, but I did have a few that were 218+. Still just fine for plinking, especially at this price. As usual, I started low and built up in powder charge. They all fed great and locked the bolt back, and they were all subsonic. I'm already planning on purchasing a couple thousand more soon! And best of all, they are a company in my home state!

Great for subsonic. Accurate and reliable. Loaded 11.2 grains A1680 seated to 2.20" OAL.